Intro Device ID

JungleFlasher will prompt you with instructions JungleFlasher will prompt you with instructions Click Yes the Running Log will display something similar to this Click Yes the Running Log will display something similar to this When are appearing, do as previously instructed by JungleFlasher. Power off the drive, then within 1 second power it back on. The drive should be in Vendor mode (0x73) now and return good flash chip properties, you can check in the Running Log or Flash Chip Properties,...

Writing Firmware to the drive

To write the firmware, as long as drive is still unlocked we just click MTKFlash32 tab Firmware ool 32 DVD Key 32 M7K Flash 32 Hitachi G DR3120 Sourcs Inquirv Identify Drive Serial Verfify you have good flash chip properties still Verfify you have good flash chip properties still Flash Chip Properties Vendor ID 0xC2 Device ID 0x11 Name MXIC(MX25L2005) Size 262144 bytes Write Command, will send Chip Erase prior to writing and then proceed to write the 4 banks of A series of 16 's are it writing...

Using a Connectivity Kit Xtractor to power the drive

The easiest way to do this is to use manual eject before powering the drive, to manual eject simply push this slider along until Tray is released Then, pull the tray out fully and push half way back in. Now, hook it up to the PC using Connectivity Kit and Sata and power on. With the correct eject tray status we can run DVDKey32 either from Command Line, or as Open JungleFlasher, you will be presented with the Welcome Screen After a few seconds the main window will load. After a few seconds the...

BenQUnLock Stock iXtreme 11 141 Xtreme Firmwares Only

Please note, BenQ-Un-Lock WILL NOT work on drives that have iXtreme 1.5 firmware on them (please use VCC Trick or Half Open Tray) Connect your BenQ drive up via sata to your PC, power on, and run JungleFlasher. You will be presented with the Welcome Screen shown below. After a few seconds you will be taken to the main application Click the MTKFlash32 Tab Firmware oqI 32 DVDKsv32' J LL0ash32 Hitachi GDR3120 Source inquiry Identify Erive Serial Then, select correct I O Port by verifying PBDS...

Drives

For this method, we still need to power on the drive with the half open tray If using a 360 to power the drive this method can be tricky to accomplish. You need to power on the drive with Eject status closed but Tray Half Open - To do this using an Xbox 360 as Power source, eject the DVD drive, then, press eject to 'close' the tray. Now this is the important part - you MUST remove the DVD power plug from the DVD Drive BEFORE it Wait for a few seconds and replace the power plug into the DVD...